Mitsubishi Electric MELFA RV-SD Series Installation Description page 46

Unpacking the robot system
RV-3SD/SDJ, RV-6SD/6SDL, RV-3SQ/3SQJ and RV-6SQ/6SQL
The robot arm is packaged in a box. The following figure shows you step-by-step how to unpack the
robot arm.
Use a knife or similar object to open the packaging tape, as shown in
Using both hands, remove the upper part of the packaging as shown in
Remove the four screws with which the base is screwed onto the lower section.
Transport the robot arm to the place of installation, as described in Section 3.2.
NOTE Keep the packaging and transport locks for later transport.
Fig. 3-2: Unpack articulated arm robot RV-3SD/SDJ, RV-6SD/6SDL, RV-3SQ/3SQJ and RV-6SQ/6SQL
3 - 2
Packing tape
Fork lift
Handle
(both sides)
Robot arm
Installation
.
.
R001296C