Other Settings (Utility) - Yamaha TYROS Owner's Manual

Reference
Making Global and Other Important Settings – Function

Other Settings (Utility)

Parameters set on the display called up by selecting "UTILITY" in step #2 of the Basic Procedure on page 150 are explained
below.
I CONFIG1
...............................................................................................................................................................
The following parameters can be set from the [FUNCTION] → UTILITY → CONFIG1 display.
G Parameters related to the Fade In/Out (page 109)
FADE IN TIME
FADE OUT TIME
FADE OUT HOLD TIME
G Parameters related to the Metronome
The metronome provides a click sound, giving you an accurate tempo guide when you practice,
or letting you hear and check how a specific tempo sounds. The metronome starts by pressing
the METRONOME [START/STOP] button. Adjust the tempo by using the [TEMPO] buttons
(page 109). To stop the metronome, press the [START/STOP] button again.
VOLUME
SOUND
TIME SIGNATURE
G Parameter Lock
This function is used to "lock" the specified parameters so that they can only be changed directly via the panel controls
— in other words, instead of being changed via Registration Memory, One Touch Setting, Music Finder, or song and
sequence data.
When the Split Point parameter is locked, for example, the Split Point settings will not be changed via the Registration
Memory, One Touch Setting, Music Finder. However, you can change the Split Point settings directly from the [FUNC-
TION] → SPLIT POINT display.
G Parameters related to the Tap (page 109)
This allows you to set the drum voice and the velocity which will sound when the Tap function is used.
I CONFIG2
...............................................................................................................................................................
The following parameters can be set from the [FUNCTION]→UTILITY→CONFIG2 display.
G Display Voice Number
Determines whether or not the voice bank and number are shown in the Voice selection display (Open/Save display).
This is useful when you want to check the proper bank select MSB/LSB values and program number to specify when
selecting the voice from an external MIDI device.
G Speaker
Determines whether or not the optionally installed speaker will sound.
HEADPHONE SW
ON
OFF
I DISK
.......................................................................................................................................................................
From the [FUNCTION] → UTILITY → DISK display, you can set or execute important disk-related operations (below)
for the TYROS.
Compatible disk types
G Floppy disk
156
TYROS Owner's Manual
Determines the time it takes for the volume to fade in, or go from minimum to maximum (range
of 0 - 20.0 seconds).
Determines the time it takes for the volume to fade out, or go from maximum to minimum (range
of 0 - 20.0 seconds).
Determines the time the volume is held at 0 following the fade out (range of 0 - 5.0 seconds).
Determines the level of the metronome sound.
Determines whether a bell accent will be sounded or not at the first beat of each measure.
Determines the time signature of the metronome sound. Normally, the value matching to the
selected style or song is set.
Speaker sounds normally, but is cut off when headphones are inserted to the
PHONES jack.
Speaker sound is always on.
Speaker sound is off.
• Make sure to read the section
"Using the Floppy Disk Drive
(FDD) and Floppy Disks" on
page 6.
G Internal hard disk drive
(optionally installed)
See page 162 for details
on hard disk installation.
METRONOME
START/
STOP