Multi Pad Realtime Recording - Yamaha TYROS Owner's Manual

I Multi Pad Realtime Recording
The explanations here apply when you call up the RECORD page in step #4 of the Basic Procedure on
page 124.
1 Select a particular Multi Pad for recording. If you
want to create the Multi Pad data from scratch,
press the [NEW BANK] LCD button to call up an
empty bank.
3
Turn Repeat of
each pad On or
Off.
Enter a name for each Multi
5
Pad, as desired.
G Repeat On/Off
If the Repeat parameter is on for the selected pad, playback of the corresponding pad will continue
until the MULTI PAD [STOP] button is pressed. When you press the Multi Pads of which the Repeat
is turned on during song or style playback, playback will start and repeat in sync with the beat.
If the Repeat parameter is off for the selected pad, playback will end automatically as soon as the end
of the phrase is reached.
G Chord Match On/Off
If the Chord Match parameter is on for the selected pad, the corresponding pad is played back accord-
ing to the chord specified in the chord section of the keyboard generated by turning [ACMP] on, or
specified in the LEFT voice section of the keyboard generated by turning [LEFT] on (when turning
the [ACMP] off).
I Multi Pad Step Recording using the Event List
The explanations here apply to when you call up the EDIT page in step #4 of the Basic Procedure on
page 124. The EDIT page indicates the Event list that lets you record notes with absolutely precise
timing. This Step Recording procedure is essentially the same as that for Song Recording (pages 100 -
105), with the exception of the points listed below:
• There is no LCD button for switching channels, since Multi Pads contain data for only a single
channel.
• In the Multi Pad Creator, only the channel events and System Exclusive messages can be entered.
Chord and Lyrics events are not available. You can switch between the two types of Event Lists by
pressing the LCD [F] button.
............................................................................................
Execute the Realtime
2
Recording.
6
After you've finished cre-
ating/editing a Multi Pad,
make sure to execute the
Save operation (page 69).
4
Turn Chord Match of
each pad On or Off.
G Start recording
Press the [REC] LCD button to enable
Synchro Start. Recording begins automat-
ically as soon as you play on the key-
board.
You can also start recording by pressing
the STYLE CONTROL [START/STOP]
button. This lets you record as much
silence as you want before the start of the
Multi Pad phrase.
If Chord Match is set to on for the Multi
Pad to be recorded, you should record
using the notes of the C major seventh
scale (C, D, E, G, A and B).
C R C
G Stop recording
Press the [STOP] LCD button or the panel
MULTI PAD [STOP] button to stop record-
ing when you've finished playing the
phrase.
..........................................................
Reference
The Multi Pads
C = Chord note
C, R = Recommended note
C R C
125
TYROS Owner's Manual