YOODA SMART CONTROL UNIT Manual page 6

www.sukcesgroup.pl
In order to fully explore available functions of YOODA SMART CONTROL UNIT (YSC_UNIT) please take a moment and read this manual before using
the device.
All devices work on 433 MHz frequency.
5. Configuration and work mode
5.1 Adding devices
Information on how to add radio receiver can be found in instruction of that device.
Yooda SmartControl
My home My scenarios Settings YOODA shop
Devices
Devices groups
Network connections
Date, time
Advanced
In the 'Settings' tab press 'Devices'.
5. Configuration and work mode
5.2 Controlling devices
Yooda SmartControl
Device
Device type
Outside shutter
Device name
Bedroom
impulse mode
deactivated
Device control
Prog
OK Cancel
Recently performed action is marked in the app.
As radio receivers can be controlled with different devices with app, recently performed action may not represent the state
of the radio receiver status.
Widgets can be created for app installed on Android system.
Widgets allow for different devices to be controlled even more easily without the need to run the app. It can be switched
between local network and remote access service, the size of the widget can be changed. It is functional and makes it
easier for different devices even faster - e.g. when driving into the garage less focus is needed to control the app.
YOODA SMART CONTROL UNIT
Yooda SmartControl
LAN
Add device
Roller blind
Projection screen
Curtain 1
Curtain 2
Light
Socket
Gate
Close
Tap 'Add device'.
Controlling of the devices can be
performed by using controlling
buttons. There are 4 types of
control depending on the device.
1. Standard control
Control is performed via three
buttons – 'UP', 'STOP', 'DOWN'.
This mode is best to control roller
shutters or roller blinds, horizontal
blinds, projection screen, roller gate
etc.
2. Horizontal control
Control is performed via three
buttons – 'OPEN', 'STOP', 'CLOSE'.
(e.g. curtains, awnings or pergolas).
Yooda SmartControl
Device
The name of the device must be unique, other
device cannot share the same name.
Device type
Outside shutter
Device name
Impulse mode
deactivated
Cancel Next
Choose type of the device and
specify its name, than press 'Next'.
3. On / off control
Device is controlled by two witches
- on and off, e.g. lighting, power
socket.
4. Step-by-step control
Device is controlled with a single
switch, e.g. sectional garage door,
up and over garage door,
double-leaf garage door, sliding
gate, garden watering system.
Yooda SmartControl
Device
Device type
Outside shutter
Device name
Bedroom
Impulse mode
deactivated
Device control
Prog
OK Cancel
Using programming button 'Prog' and
controlling buttons add device using
instruction of the radio receiver.
5. Impulse control
Some devices, such as roller blind
and horizontal blind, can be
controlled using impulse mode.
Before choosing this type of
control device needs to be set to
impulse as it is described in its
instruction. Activating impulse
mode changes control buttons.
Control buttons will be sending
amount of impulses equal to the
length of uninterrupted time of button
being pushed. Motor works as long
as the button is being pushed.
Pushing button longer than for
2 seconds will result in moving
the shade to its limit position.