Connecting To An Ibm-Pc/At Series Computer - Yamaha P-120 P-120S Owner's Manual

Connecting to a Personal Computer

Connecting to an IBM-PC/AT Series Computer

Connect the TO HOST connector of the P-120/P-120S to the
RS-232C port on your IBM computer, using a standard 8-pin
MINI DIN → 9-pin D-SUB cross cable. Set the HOST SELECT
switch to the "PC-2" position.
Refer to your software owner's manual for information on any
settings you might have to make on the computer side.
G "PC-2" Cable Connections
MINI DIN
8-PIN 1
2
3
4
8
5
• 8-pin mini DIN → 9-pin D-SUB cable.
• Data transfer rate: 38,400 bps.
• If your system doesn't work properly with the connections and settings listed above, your software may require dif-
NOTE
ferent settings. Check your software operation manual and if it requires a 31,250 bps. data transfer rate, set the
HOST SELECT switch to "PC-1".
• When using the TO HOST terminal to connect to a personal computer using Windows, a Yamaha MIDI driver must
be installed in the personal computer. The Yamaha MIDI driver can be obtained at Yamaha's home page on the
World Wide Web, <http://www.yamaha-xg.com/>.
G Connector Pin Numbers
MINI DIN 8-PIN
6 7 8
3 4
1 2
D-SUB 9-PIN
5 4 3
9 8 7
42
P-120/P-120S
8 (CTS)
7 (RST)
2 (RxD)
5 (GND)
3 (TxD)
5
2 1
6
Set to the "PC-2"
D-SUB
9-PIN
position.
IBM-PC/AT
Series Computer