Device Configuration - Siemens SIMATIC S5 1P 243 Equipment Manual

Programming Instructions
This example shows the operation of the analog module 1P 243. By means of a simulator the indi-
vidual functions can be selected (via binary inputs). The signal states can be displayed via binary
outputs. The display shows how an analog value applied to the module can be read and how an
analog value can be output via the module.
This example also shows the necessary jumper settings and wiring requirements for the mo-dule.
Therefore, it can also be used as a test program to check the jumper settings and functions of the
module.

7.4.1 Device Configuration

For a test of the analog module 1P 243, the following devices can be used:
– One of the listed programmable controllers
– Programmer (e.g., PG 750)
– Analog module 1P 243 (6ES5 243–lAA11) in full configuration: front connector K with screw
mounting (6)(X3 081)
– Digital input module; front connector with screw mounting
– Digital output module; front connector with screw mounting
– 2 simulators (6ES5788–0L412)
– Voltage source for two analog signals
– Voltmeter
7 – 12
R 02/92
AG 1989, Order No: 6ES5 998-0KF21