20-Port 10-Ge Plim With Xfp Optics Modules - Cisco CRS-1 System Description

20-Port 10-GE PLIM with XFP Optics Modules

Caution
A CFP optics module must be installed in the CFP transceiver module slot of each 100GE PLIM installed in
the Cisco CRS chassis. The CFP transceiver module preserves the integrity of the card and is required for
EMI and Safety compliance and proper cooling in the chassis.
Table 14: CFP Module Port Cabling Specifications
Part Number
CFP-100GE-LR4,
V01
20-Port 10-GE PLIM with XFP Optics Modules
The 20-port 10-GE XFP PLIM supports from one to twenty pluggable XFP optics modules.
The 20-port 10-GE PLIM has:
• Twenty ports that accept XFP optics modules
• Status LED for the PLIM
• Port status LED for each port
Note
For information about the XFP optical transceiver modules supported on the 20-port 10-GE XFP PLIM, see
Cisco CRS Carrier Routing System Ethernet Physical Layer Interface Module Installation Note.
Note
The 20-port XFP PLIM has a fixed power budget for the pluggable XFP optics. See
Management
The 20-port 10-GE PLIM supports the following types of XFP optical transceiver modules:
• Single-mode low power multirate XFP module—XFP10GLR-192SR-L, V01
• Single-mode low power multirate XFP module—XFP10GER-192IR-L, V01
Cisco qualifies the optics that are approved for use with its PLIMs.
For the modules listed, use a single-mode optical fiber that has a modal-field diameter of 8.7 ±0.5 microns
(nominal diameter is approximately 10/125 micron) to connect your router to a network.
The following figure shows the front panel of the 20-Port 10-GE XFP PLIMs.
Cisco CRS Carrier Routing System 8-Slot Line Card Chassis Enhanced Router System Description
64
Description
100-GE pluggable
optical transceiver
modules
for detailed information.
Line Cards and Physical Layer Interface Modules Overview
Wavelength Fiber Type
1295.56 nm1300.055 SMF
nm1304.585 nm1309.14
nm
Typical Maximum
Distance
6.213 miles
(10 km)
XFP Optics Power