Cisco CRS-1 System Description page 70

8-Port 10-GE PLIM with XFP Optics Modules
• LED for each port
Note
For information about the XFP optical transceiver modules supported on the 8-port 10-GE XFP PLIM, see
Cisco CRS Carrier Routing System Ethernet Physical Layer Interface Module Installation Note.
The 8-port 10-GE XFP PLIM supports the following types of XFP optical transceiver modules:
• Single-mode low power multirate XFP module—XFP10GLR-192SR-L, V01
• Single-mode low power multirate XFP module—XFP10GER-192IR-L, V01
Cisco qualifies the optics that are approved for use with its PLIMs.
For the modules listed, use a single-mode optical fiber that has a modal-field diameter of 8.7 ±0.5 microns
(nominal diameter is approximately 10/125 micron) to connect your router to a network.
The following figure shows the front panel of the 8-Port 10-GE XFP PLIM.
Figure 41: 8-Port 10-Gigabit Ethernet XFP PLIM front panel
1 Port LED (one per port)
The following table describes the PLIM LEDs for the 8-Port 10-GE XFP PLIM.
Table 9: 8-Port 10-GE XFP PLIM LED Descriptions
LED State
Status Green
Yellow
Off
Port On
Off
The 8-port 10-GE XFP PLIM power consumption—88 W (with eight optics modules)
The following table provides cabling specifications for the XFP modules that can be installed on the 8-port
10-GE XFP PLIM.
Cisco CRS Carrier Routing System 8-Slot Line Card Chassis Enhanced Router System Description
60
2 Status LED
Description
PLIM is properly seated and operating correctly.
PLIM has a problem.
PLIM is not properly seated or system power is off.
Port is logically active and the laser is on.
Port is not active.
Line Cards and Physical Layer Interface Modules Overview