4-Port 10-Ge Plim With Xfp Optics Modules - Cisco CRS-1 System Description

Line Cards and Physical Layer Interface Modules Overview
Table 10: XFP Module Port Cabling Specifications for the 8-Port 10-GE XFP PLIM
Part Number
XFP10GLR-192SR-L,
V01
XFP10GER-192IR-L,
V01

4-Port 10-GE PLIM with XFP Optics Modules

The 4-port 10-GE XFP PLIM supports from one to four pluggable XFP optics modules. The 4-port 10-GE
XFP PLIM has:
• Four ports that accept XFP optics modules
• Status LED for the PLIM
• LED for each port
Note
For information about the XFP optical transceiver modules supported on the 8-port 10-GE XFP PLIM, see
Cisco CRS Carrier Routing System Ethernet Physical Layer Interface Module Installation Note.
The 4-port 10-GE XFP PLIM supports the following types of XFP optical transceiver modules:
• Single-mode low power multirate XFP module—XFP10GLR-192SR-L, V01
• Single-mode low power multirate XFP module—XFP10GER-192IR-L, V01
Cisco qualifies the optics that are approved for use with its PLIMs.
For the modules listed, use a single-mode optical fiber that has a modal-field diameter of 8.7 ±0.5 microns
(nominal diameter is approximately 10/125 micron) to connect your router to a network.
The following figure shows the front panel of the 4-Port 10-GE XFP PLIM.
Figure 42: 4-Port 10-Gigabit Ethernet XFP PLIM Front Panel
1 Port LED (one per port)
The following table describes the PLIM LEDs for the 4-Port 10-GE XFP PLIM.
Description
Low Power multirate XFP
supporting 10GBASE-LR and
OC-192 SR
Low Power multirate XFP
supporting 10GBASE-ER and
OC-192 IR
2 Status LED
Cisco CRS Carrier Routing System 8-Slot Line Card Chassis Enhanced Router System Description
4-Port 10-GE PLIM with XFP Optics Modules
Wavelength Fiber Type Typical Maximum
Distance
1310 nm SMF 6.213 miles
(10 km)
1550 nm SMF 24.85 miles
(40 km)
61