Reverb
You can also select the Reverb Type by using the REVERB TYPE
buttons, or by pressing REVERB TYPE (to highlight the parameter)
and using the data dial or [–/+] buttons.
Reverb Type List
HALL1
HALL2
HALL3
HALL4
HALL5
ROOM1
ROOM2
ROOM3
ROOM4
STAGE1
STAGE2
STAGE3
PLATE
WHITE ROOM
TUNNEL
BASEMENT
Setting the Total Depth
The overall depth of the selected Reverb Type can be set with the
Total Depth parameter (TOTAL DEPTH
You can also set it by pressing TOTAL DEPTH
and using the data dial or [–/+] buttons.
The values can be changed in 5-unit steps. To reset the value to the
basic setting of 50, simultaneously press REVERB TYPE
taneously press the [–/+] buttons.
42
CVP-98/96/600
Concert hall reverb.
Small room reverb.
Reverb for solo instruments.
Simulated steel plate reverb.
Distinctive short reverb with initial delay.
Simulation of long tunnel-like space.
Small, highly reflective room reverb.
).
(it is highlighted)
or simul-
• The Reverb Type setting globally
affects all voices. Different settings
cannot be made for each voice.
• The indication "XG REVERB" is dis-
played when receiving via MIDI a
reverb type which is not on the panel.
Keep in mind...
• Depending on the selected voice, the
depth of the effect may sound stronger
or weaker, even though the same
Reverb Type is selected.
• The effect cannot be applied to the
sounds input through the AUX IN [R]
[L/L+R] jacks.
• If the Reverb Type in Effect (page 45)
is selected and both [REVERB] and
[EFFECT] are set to on, both reverb
effects will be applied.
Total Depth
• Range: 0 (no effect) — 100 (maxi-
mum)
• Basic setting: 50
• Backup of last settings: OFF
• The Total Depth setting globally affects
all voices. Different settings cannot be
made for each voice.
• Different Reverb Depth settings can be
made for each part. (Refer to the next
section.)