Pride POWER ASSIST Owner's Manual page 7

Trigger – Squeeze the trigger to propel the PowerAssist. The more the trigger is squeezed, the
faster the PowerAssist will travel. Release the trigger to stop the PowerAssist
Speed Dial – Turn the dial clockwise to increase the maximum speed of the PowerAssist. Turn the
dial anticlockwise to reduce the PowerAssist's maximum speed.
Inner Knob – This is used to determine the angle of the handle set.
Outer Knob – This is used to secure the clip holding the handset to the push handle.
Power Eye – This is lit green when the PowerAssist is switched on.
1. Switch the PowerAssist off at the ignition.
2. Disconnect / unclip the powerpack connector from underneath the handset and battery
pack.
3. Remove the lift-up strap from the push handle.
4. Lift the battery pack out of the battery tray.
5. Remove the powerpack by loosen the tristar knob(see the photo below)
Notes:
● The battery pack and power pack have fabric handles to make them easier to carry.
DISASSEMBLY &
TRANSPORTATION