Audio I/O Connection; Analog Audio Connection ([In] And [Out] Connectors) (Dme24N Only) - Yamaha WK83840 Owner's Manual

Audio I/O Connection

Analog Audio Connection ([IN] and [OUT] Connectors) (DME24N only)

The DME24N includes [IN] and [OUT] connectors for 8 channels of analog audio input and output. Wire
the supplied Euroblock plugs as shown below. Head amplifier gain and phantom power settings can be made
via the Utility display HA page described on page 54 of this manual, or via the DME Designer application.
Euroblock Connection
Please be sure to use the supplied Euroblock plugs. If you lose them, contact your nearest Yamaha dealer.
• To prepare the cable for attachment to a Euroblock connector, strip the wire
as shown in the illustration, and use stranded wire to make connections.
With a Euroblock connection, the stranded wire may be prone to breakage
because of metal fatigue due to the weight of the cable or due to vibration.
When rack-mounting your equipment, use a lacing bar when possible to
bundle and fasten the cables.
• If cables will be frequently connected and disconnected, as in the case of a
portable installation, we recommend that you use ferrules with insulation
sleeves. Use a ferrule whose conductor portion has an external diameter of
1.6 mm or less, and a length of approximately 7 mm (such as the AI0,5-
6WH made by the Phoenix Contact corporation).
If you use stranded wire, do not tin (plate with solder) the exposed end.
CAUTION
1.
Loosen terminal screws.
N OT E
A slotted screwdriver with a blade width of about 3 millimeters is recommended.
2.
Insert cables.
26
DME64N/DME24N Owner's Manual
Cable preparation
Loosen.
Slotted Screwdriver
Terminal Screw
Euroblock Plug
approx.
7 mm
1.6 mm approx.
or less 7 mm
3 mm