Mercedes-Benz A-Class 2020 Operator's Manual page 323

Position jack 2 at jack support point 1.
#
% If there is a total loss of pressure in a tire, it
may be possible that the jack cannot be
positioned at jack support point 1. In this
case, unload the vehicle.
Turn ratchet 3 clockwise until jack
#
completely on jack support point
base of the jack lies evenly on the ground.
Turn ratchet 3
#
mum of 1.2 in (3 cm) from the ground.
Loosen and remove the wheel (
#
Removing a wheel
Requirements:
The vehicle is raised (
R
When changing a wheel, avoid applying any force
to the brake discs, since this could impair the
level of comfort when braking.
* NOTE Damage to threading from dirt on
wheel bolts
Do not place wheel bolts in sand or on
#
a dirty surface.
Unscrew the uppermost wheel bolt com‐
#
pletely.
2 sits
1 and the
until the tire is raised a maxi‐
page 321).
/
page 319).
/
#
#
#
#
#
Mounting a new wheel
Requirements:
R
Wheels and tires 321
Screw alignment bolt 1 into the thread
instead of the wheel bolt.
Unscrew the remaining wheel bolts fully.
Remove the wheel and, if necessary, store it
in the cargo compartment.
Notes on removing an emergency spare
wheel ( page 323).
/
Install the new wheel ( page 321).
/
The wheel is removed ( page 321).
/