Create A New Analog Trunk; Figure 3: Create A New Analog Trunk; Figure 4: Analog Trunk Configuration Page - Grandstream Networks UCM6 Series Manual

Create a New Analog Trunk

To create a new analog trunk:
1. Go to Web GUI→PBX→Extension/Trunk→Analog Trunks.
2. Click on
3. The following figure will pop up, allowing users to configure the connected analog lines to the FXO port.
Please refer to the following table for Analog Trunk configuration parameters.
to add a new analog trunk.

Figure 3: Create a New Analog Trunk

Figure 4: Analog Trunk Configuration Page

UCM6XXX Analog Trunks Guide
P a g e | 7