Standby Mode; Power Supply Of The On-Board Computer - Bosch Nyon Original Operating Instructions

or the operating unit of the eBike, the eBike system, and therefore also the
battery, will switch off automatically to save energy.
Nyon (BUI350) goes into standby mode as a result.

Standby Mode

You can put your on-board computer into a standby mode, which enables
the on-board computer and system to start up more quickly.
Standby mode can be activated as follows:
– To do this, press the on/off button (3) on the on-board computer for at
least 1 second, but no longer than 3 seconds.
– Wait 10 minutes until the system switches off.
– Switch the battery off using the on/off button on the battery.
Pressing the on/off button (3) on the on-board computer for at least
1 second ends standby mode.
Standby mode ends and the on-board computer automatically switches off if
the state of charge of the on-board computer's battery is less than 75 %. In
any case, the on-board computer switches off at midnight (00:00) at the
latest.
If Nyon (BUI350) cannot be switched on or does not work properly, press
and hold the on/off button (for approx. 15 seconds). This may correct the
malfunction.

Power supply of the on-board computer

If the on-board computer is in the holder (4), a sufficiently charged eBike
battery is inserted into the eBike and the eBike system is switched on, then
the on-board computer battery is powered and charged by the eBike bat-
tery.
If the on-board computer is removed from the holder (4), the power is sup-
plied by the on-board computer battery. If the on-board computer battery's
charge is running low, a warning message appears on the display.
Colour of the indicator
Green
Orange
Bosch eBike Systems
Explanation
The rechargeable battery of the on-
board computer is charged over
30 %.
The rechargeable battery of the on-
board computer is charged between
15 % and 30 %.
1 270 020 Nen | (31.08.2020)
English – 17