Advertisement
www.Securitykala.com | 031-91003037 09133648641
Logic
Definition
Configuration of
EXPO2 output
EXPO1
on input-output
expansion board
4-5
Configuration of
EXPO2 output
EXPO2
on input-output
expansion board
6-7
TRAFFIC LIGHT
Traffic light pre-
flashing
PREFLASHING
TRAFFIC LIGHT
RED LAMP
Steadily lit red light
ALWAYS ON
TABLE "C" – RADIO MENU (RADIO)
Logic
Description
Add Start Key
Add start
associates the desired key with the Start command
Add 2ch Key
associates the desired key with the 2nd radio channel command. Associates the desired key with the 2nd radio channel command. If no output
add 2ch
is configured as 2nd Radio Channel Output, the 2nd radio channel controls the pedestrian opening.
Erase List
WARNING! Erases all memorized transmitters from the receiver's memory.
erase 64
Read receiver code
Displays receiver code required for cloning transmitters.
ON = Enables remote programming of cards via a previously memorized W LINK transmitter.
It remains enabled for 3 minutes from the time the W LINK transmitter is last pressed.
OFF= W LINK programming disabled.
INSTALLATION MANUAL
Cross out
Default
setting
used
0
Output configured as 2
1
Output configured as SCA (gate open light).
9
2
Output configured as Courtesy Light command.
3
Output configured as Zone Light command.
4
Output configured as Stair Light.
5
Output configured as Alarm.
6
Output configured as Flashing light.
9
7
Output configured as Latch.
8
Output configured as Magnetic lock.
9
Output configured as Traffic Light control with TLB board.
0
Pre-flashing switched off.
0
1
Red lights flash, for 3 seconds, at start of operation.
0
Red lights off when gate closed.
0
1
Red lights on when gate closed.
Optional extras
Radio Channel.
nd
LEO B CBB 3 230 L02/L04 - LEO B CBB 3 120 F02 / F04
29
-
Advertisement
