Pitco MGII Technical Service And Exploded Parts page 2

THE OIL LEVEL SHOULD NOT FALL BELOW THE MINIMUM INDICATED LEVEL AT ANY
TIME. THE USE OF OLD OIL CAN BE DANGEROUS AS IT WILL HAVE A REDUCED FLASH-
INSTALLATION AND ALL CONNECTIONS MUST BE MADE ACCORDING TO NATIONAL
A COUNTRY APPROVED ALL POLE CIRCUIT BREAKER WITH A MINIMUM OPEN CON-
TACT GAP OF 3mm MUST BE USED FOR PROPER INSTALLATION.
THE FRYER IS NOT JET STREAM APPROVED. DO NOT CLEAN THE APPLIANCE WITH A
INSTALLATION SHOULD ONLY BE DONE BY A COMPETENT SERVICE TECHNICIAN. THE
MODEL & SERIAL NUMBER, AND ELECTRICAL REQUIREMENTS STAMPED INTO THE
DATA PLATE, LOCATED ON THE INSIDE PANEL OF THE DOOR.
THIS APPLIANCE IS INTENDED FOR PROFESSIONAL USE ONLY , AND AS SUCH,
SHOULD BE OPERATED BY FULLY TRAINED PERSONNEL.
IT IS RECOMMENDED THAT THIS MACHINE BE INSPECTED BY A QUALIFIED TECHNI-
THE POWER SUPPLY MUST BE DISCONNECTED SERVICING OR CLEANING THE UNIT .
SHORTENING , WHEN IT IS AT OPERATING TEMPERATURES, IS VERY HOT AND
DANGEROUS! USE EXTREME CAUTION WHEN HANDLING! USE PROPER PROTEC-
TIVE GEAR SUCH AS INSULATED GLOVES, APRONS, FACE SHIELD, AND SLEEVES
WHEN HANDLING HOT SHORTENING . DO NOT ATTEMP TO MOVE MACHINE THAT HAS
HOT OIL IN IT . ALLOW TO COOLTO ROOM TEMPERATURE OR DRAIN THE OIL INTO A
SUITABLE
L22-236 Rev 0 (04/03)
WARNING! FIRE HAZARD
POINT AND BE MORE PRONE TO SURGE BOILING .
AND LOCAL REGULATIONS AND CODES IN FORCE.
CIAN ON A YEARLY BASIS.
CONTAINER BEFORE MOVING THE FRYER.
WARNING
WARNING
WARNING
WATER JET .
NOTICE
NOTICE
NOTICE
WARNING
WARNING
4/7/03-1