Keyboard Stand Assembly - Yamaha CLAVINOVA C L P - 3 8 Owner's Manual

Keyboard Stand Assembly

CAUTION
• Be careful not to confuse parts, and be sure to install all parts in the correct direction. Please assemble in accordance
with the sequence given below.
• Assembly should be carried out by at least two persons.
• Be sure to use the correct screw size, as indicated below. Use of incorrect screws can cause damage.
• Assemble the stand on a flat floor with ample space.
• Be sure to tighten up all screws upon completing assembly of each unit.
• To disassemble, reverse the assembly sequence given below.
Have a Phillips-head (+) screwdriver of the appropriate size ready.
Remove all parts from the box. Confirm that all parts shown in the illustration are provided.
Connector
panel
Pedal cord
E
A
AC IN
Styrofoam pads
Take out the styrofoam pads, and place A on top of the pads.
Position the styrofoam pads to protect the connector panel at
the bottom of A and the AC IN.
B
C
D
F
6 x 25mm long screws x 4
6 x 16mm short screws x 6
4 x 14mm thin screws x 8
4 x 20mm tapping screws x 5
4 x 10mm thin screws x 2
Headphone hanger
Cord holders x 2
AC power cord
(The shape of plug
differs depending
on locale.)
117
CLP-380 Owner's Manual