Keyboard Stand Assembly (Dgx-500 Only) - Yamaha PortableGrand DGX-300 Owner's Manual

Keyboard Stand Assembly
• Be careful not to confuse parts, and be sure to install all parts in the
correct direction. Please assemble in accordance with the sequence
given below.
• Assembly should be carried out by at least two persons.
• Be sure to use the correct screw size, as indicated above. Use of
incorrect screws can cause damage.
• Be sure to tighten all screws upon completing assembly of each unit.
• To disassemble, reverse the assembly sequence given below.
I Assembly Parts (DGX-500 only)
1
(DGX-500 only)
Back board
q
6 x 70 mm round head screws (4 pcs.)
w
Joint connectors (4 pcs.)
e
3.5 x 16 mm tapping screws (12 pcs.)
w
Joint connectors
q
6 x 70 mm round head screws
Have a phillips-head (+) screwdriver ready.
The parts shown in the "Assembly Parts" illustration will
be used. Follow the assembly instructions and select
the parts as needed.
r
t
y
Z
Attach the stand bases.
Making sure that the boards are facing the proper direc-
tion (the holes should face inside), insert the joint connec-
w
tors into the holes as shown. The joint connectors have
been installed properly if you can see a plus mark on the
connector.
Attach the stand bases to the rear of the side boards,
using the 6 x 70 mm round head screws
Side boards
Stand bases
6 x 30 mm round head screws (4 pcs.)
5 x 16 mm round head screws (4 pcs.)
Angle brackets (4 pcs.)
q
.
105