Connect The Power Cord - Yamaha CLAVINOVA C L P - 3 8 Owner's Manual

Keyboard Stand Assembly
7.
Attach C.
7-1
Place on D, the stopper-wood at the bottom edges
of C, then secure the top.
7-2
Secure upper right and left of C using two 4 x
14mm thin screws.
7-3
Secure upper center and lower of C using five
4 x 20mm tapping screws.
7-1
D
C
7-3
8.

Connect the power cord.

Insert the AC power cord plug into the [AC IN].
240
127
120
CLP-380 Owner's Manual
7-2
C
For models that feature
a voltage selector:
Set the voltage selector to an
appropriate voltage.
Voltage Selector
Before connecting the AC power cord, check the setting of
the voltage selector which is provided in some areas. To set
the selector for 110V, 127V, 220V or 240V main voltages,
use a "minus" screwdriver to rotate the selector dial so that
the correct voltage for your region appears next to the
pointer on the panel. The voltage selector is set at 240V
when the unit is initially shipped.
After the proper voltage has been selected, connect the AC
power cord to the [AC IN] and an AC wall outlet. A plug
adaptor may be also provided in some areas to match the
pin configuration of the AC wall outlets in your area.
WARNING
An improper voltage setting can cause serious damage to
the Clavinova or result in improper operation.
9.
Set the adjuster.
Rotate the adjuster until it comes in firm contact
with the floor surface.
10.
Attach the headphone hanger.
You can attach a headphone hanger on the
Clavinova to hang the headphones.
Install the headphone hanger using included two
screws (4 x 10mm) as shown in the figure.