Programming The Remote Control - Becker Centronic SunWindControl SWC745-II Assembly And Operation Instructions Manual

Programming the remote control

Note
The central command 1-5 cannot be programmed
separately.
1) Programming the master transmitter
a) Readying the receiver for programming
Note
Follow the Assembly and Operating Instructions for
the receiver.
Operate the programming button on the transmitter
using a suitable cylindrical tool (e.g. a ballpoint
pen).
▪ Switch off the power supply to the receiver for 5 seconds, then
switch it back on.
or
▪ Operate the programming button or the radio switch of the receiv‐
er.
The receiver is now in Programming mode for 3 minutes.
b) Programming the master transmitter
Press the programming button on the master transmitter whilst in
Programming mode until the receiver confirms that programming
was successful.
On the display, "Transmit setting" appears
Confirm with OK.
The programming process is now complete.
2) Programming additional transmitters
Press the programming button of the master transmitter until the re‐
ceiver confirms.
On the display, "Transmit setting" appears
Confirm with OK.
49