Connecting External Audio Devices To The Central Unit - Sennheiser ADN Series System Instruction Manual

Putting the conference system into operation
IN –– AUDIO –– OUT
PORT II PORT I
2x 52.8V 1.75A
7
IN –– AUDIO –– OUT
PORT II PORT I
2x 52.8V 1.75A
6
IN –– AUDIO –– OUT
PORT II PORT I
2x 52.8V 1.75A
A
HDD

Connecting external audio devices to the central unit

You can use different settings for processing the audio signals of the
IN audio input and the
delayed or double audio signals in videoconferencing or teleconferencing
systems (see page 100 or page 201).
To output the floor channel via an external audio device:
Use an XLR cable to connect the
external audio device.
To connect an external audio source and to feed its signals to the floor channel:
Use an XLR cable to connect the external audio source to the
of the central unit.
Connecting a USB mass storage device for audio
recordings to the central unit
In order to be able to use the audio recording function of the ADN CU1 central
unit (see page 122), you require a USB mass storage device with the following
characteristics:
USB mass storage device
Recommended memory size > 500 GB
File system
Partition
Connection
Interface
Power supply
Connect the USB mass storage device to one of the two USB sockets
If necessary, connect the mains unit of the USB mass storage device.
Use a USB hub if the number of USB sockets
100-240V~
50/60Hz 240W
mass storage device is too large for connection to the central unit.
OUT audio output in order to avoid, for example,
7
OUT audio output of the central unit to an
Requirements
NTFS
FAT32
1
USB type A plug
USB 2.0
via USB socket (approx. 500 mA) or separate
mains unit
A
is not sufficient or if the USB
ADN Digital Conference System
6
IN audio input
A
.
| 75