Yamaha EMX-100CD Owner's Manual page 41

HOW TO USE THE BUILT-IN TIMER
2-
CD CHANGER RECEIVER EMX–100CD
DISC
1 2 3
POWER
PHONES
3
CD
1 2
1 2
6 7
6 7
A B
TIME PROG
MODE REPEAT RANDOM
DISC SKIP
CENTER/REAR
TEST FLAT
/DELAY
ECHO
MUSIC
LEVEL
POWER
SLEEP
VOLUME
POWER
2- 3
, ,
INPUT SELECTOR VOLUME
VCR/LD-TV/CD/TUNER/TAPE•MD/AUX
OPEN/
CLOSE
DISC
CHANGE
RANDOM REPEAT TIME MEMORY AUTO/MAN'L
PROGRAM
HOUR MIN TIME ADJ TIMER
PRESET/TUNING/BAND A/B/C/D/E
MUSIC
ECHO ECHO
MIC MIC MIXING
DISPLAY
USER MEMORY
MIN MAX
DISPLAY
3 4 5
3 4 5
8 PRESET
8 9 0
C D E
+
I0
OPEN/CLOSE TUNER
STOP PLAY/PAUSE
INPUT
PROGRAM USER
DISPLAY
ON TIME/time setting mode
["ON TIME" appears on the display, and soon it is
changed to a time setting mode.]
Set to the time when you want to begin the timer play
by using the HOUR button and the MIN button.
OFF TIME/time setting mode
["OFF TIME" appears on the display, and soon it is
changed to a time setting mode.]
If necessary, set to the time when you want to finish
the timer play (to turn this unit off) by using the HOUR
button and the MIN button. Even if you do not set the
time, it has already been set so that the timer play
finishes after 1 hour.
Note
The TIMER button functions also in the time (ON
TIME or OFF TIME) setting mode. (However, it also
turns off the power.)
3
If you will not use this unit until the timer play begins, turn
the power off by pressing the POWER switch or the
TIMER button.
Note
If a timer play setting is made and the power is not turned off,
the source set for the timer play will begin playing when the
time comes in place of the source played at that time.
To cancel the timer play setting
After the timer play is finished, press the DISPLAY button to
call the current time. While the current time is displayed,
press the TIMER button so that "TIMER" goes out from the
display.
If it is not canceled, this unit will be turned on at the same
time every day, so it can be used as an alarm. However, if
you are planning to go out at that time, cancel the timer play
setting.
* Unless the AC supply lead is unplugged or there is a
power failure for more than 5 minutes, the time set on the
timer will be retained until it is reset.
How to make time setting in the ON TIME or OFF
TIME mode
For the hour:
Press the HOUR button to change the hour to a higher value.
Press and hold to change continuously.
For the minute:
Use the MIN button and operate it in the same way as you
did to change the hour.
E-33