Operating External Units Connected With This Unit - Yamaha EMX-100CD Owner's Manual

OPERATING EXTERNAL UNITS CONNECTED WITH THIS UNIT

CD CHANGER RECEIVER EMX–100CD
DISC
1 2 3
POWER
PHONES
CD
1 2
1 2
6 7
6 7
A B
TIME PROG
MODE REPEAT RANDOM
DISC SKIP
CENTER/REAR
TEST FLAT
/DELAY
ECHO
MUSIC
LEVEL
POWER
SLEEP
VOLUME
3, 2 2
1 3, 2 2
INPUT SELECTOR VOLUME
VCR/LD-TV/CD/TUNER/TAPE•MD/AUX
OPEN/
CLOSE
DISC
CHANGE
RANDOM REPEAT TIME MEMORY AUTO/MAN'L
PROGRAM
HOUR MIN TIME ADJ TIMER
PRESET/TUNING/BAND A/B/C/D/E
MUSIC
ECHO ECHO
MIC MIC MIXING
USER MEMORY DISPLAY
MIN MAX
3 4 5
3 4 5
8 PRESET
8 9 0
C D E
+
I0
OPEN/CLOSE TUNER
STOP PLAY/PAUSE
INPUT
PROGRAM USER
DISPLAY
To listen to or watch a source on an
external unit connected with this
system
1
Select the position of input source (TAPE MD, AUX, VCR
or LD TV) you will play back by turning the INPUT
SELECTOR until the corresponding name appears on the
display.
* The names of input source positions correspond with
the names of terminals to connect with external units
on the rear of this unit.
2
Play back the source.
(For a video source, turn the monitor TV on.)
3
Adjust the volume to a desired level by using the
VOLUME control.
If you prefer, use the graphic equalizer and/or the sound
field processor built into this unit.
To record a source to tape
Not only a source played back on this unit, but also a source
played back on an external unit can be recorded by the tape
deck, VCR, DAT, etc. connected with this unit.
1 1
Select the source to be recorded by turning the INPUT
SELECTOR.
2 2
Play back the source and then turn the VOLUME control
up to confirm the input source.
3 3
Begin recording on the tape deck or VCR etc. connected
with this unit.
Note
If the built-in graphic equalizer and/or sound field processor
is used, its effect is recorded along with the source when you
make recording on the recording unit connected to the
TAPE MD terminals on the rear of this unit.
However, the effect of the graphic equalizer and/or sound
field processor cannot be recorded when you make recording
on the external recording unit connected to the VCR
terminals on the rear of this unit.
E-23