How To Use The Built-In Timer - Yamaha EMX-100CD Owner's Manual

HOW TO USE THE BUILT-IN TIMER

CD CHANGER RECEIVER EMX–100CD
DISC
1 2 3
POWER
PHONES
1
1
6
6
A
TIME PROG
MODE REPEAT
DISC SKIP
CENTER/REAR
TEST
/DELAY
ECHO
LEVEL
SLEEP
2-
INPUT SELECTOR
VCR/LD-TV/CD/TUNER/TAPE•MD/AUX
OPEN/
CLOSE
DISC
CHANGE
RANDOM REPEAT TIME
PROGRAM
HOUR MIN
PRESET/TUNING/BAND A/B/C/D/E
MUSIC
ECHO ECHO
MIC
USER MEMORY DISPLAY
2- * 2
CD
2 3 4 5
2 3 4 5
7 8 PRESET
7 8 9 0
B C D E
+
I0
2-
RANDOM OPEN/CLOSE TUNER
STOP PLAY/PAUSE
2-
INPUT
FLAT
MUSIC PROGRAM USER
POWER
DISPLAY
VOLUME
Timer play
By using the built-in timer, you can set the time when the unit
turns on and a source begins playing automatically, and the
time when the unit turns off automatically.
2-
1
Prepare the source to be played.
For tuner:
VOLUME
Tune in to the station you will listen to.
For CD player:
Load a disc on the disc table. If more than one disc are
MEMORY AUTO/MAN'L
TIME ADJ TIMER
loaded on the disc table, select the disc by using the
DISC selector buttons or the DISC SKIP button.
MIC MIXING
MIN MAX
2
Press the DISPLAY button.
Whenever the DISPLAY button is pressed, the display
mode changes as follows.
On each mode, make a setting for the timer play,
following the setting procedure described below.
Note
The display mode will be changed to the next mode after
about 8 seconds elapse in turn automatically. If the mode
is changed before the setting is completed, call the mode
again by pressing the DISPLAY button once or more.
Setting procedure:
Current time
Check to be sure that the current time is correct, and
press the TIMER button so that "TIMER" lights up on
the display.
Source selecting mode
Select the source (TUNER or CD) to be played with
the INPUT SELECTOR button.
* If "TUNER" is selected, soon it is changed to the
E-32
Current time (TIMER on/off mode)
Source selecting mode (TUNER, CD)
ON TIME/Time setting mode
OFF TIME/Time setting mode
Normal display mode
frequency display mode. In this mode, you can
select the station to listen to with the timer play by
using the PRESET/TUNING/BAND selector button,
A/B/C/D/E button and / buttons.