Tuning Operation - Yamaha EMX-100CD Owner's Manual

TUNING OPERATION

CD CHANGER RECEIVER EMX–100CD
DISC
1 2
POWER
PHONES
1
1
6
6
A
TIME PROG
MODE REPEAT
DISC SKIP
CENTER/REAR
TEST
/DELAY
ECHO
LEVEL
SLEEP
1
2
INPUT SELECTOR
VCR/LD-TV/CD/TUNER/TAPE•MD/AUX
OPEN/
CLOSE
DISC
CHANGE
3
RANDOM REPEAT TIME
PROGRAM
HOUR MIN
PRESET/TUNING/BAND A/B/C/D/E
MUSIC
ECHO ECHO
MIC
DISPLAY
USER MEMORY
4, 3 3
CD
2 3 4 5
2 3 4 5
7 8 PRESET
7 8 9 0
B C D E
+
I0
TUNER
RANDOM OPEN/CLOSE 1
STOP PLAY/PAUSE
INPUT
FLAT
MUSIC PROGRAM USER
POWER
DISPLAY
VOLUME
Normally, if station signals are strong and there is no
interference, quick automatic-search tuning (Automatic
tuning) is possible. However, if signals of the station you
want to select are weak, you must tune to it manually
(Manual tuning).
3, 2 2
Automatic tuning
1
Select the tuner by turning the INPUT SELECTOR until
"TUNER" appears on the display.
VOLUME
2
Select the reception band (FM or AM ) by pressing the
PRESET/TUNING/BAND button confirming it on the
MEMORY AUTO/MAN'L
TIME ADJ TIMER
display.
* Do not select a preset tuning mode (Do not select the
MIC MIXING
mode in which "PRESET" lights up on the display.)
MIN MAX
3
Press the AUTO/MAN'L button so that "AUTO" appears
on the display.
(In this mode, stations are received in stereo or monaural
automatically.)
4
Press the
press the
(When tuned in to a station, "TUNED" will light up on the
display.)
5
If the station where tuning search stopped is not the
desired one, follow step 4 again.
* If the tuning search does not stop at the desired station,
change to the Manual tuning method as described below.
* STEREO indicator will light up when an FM stereo
broadcast with sufficient signal strength is received.
Manual tuning
1 1
Follow steps 1 and 2 of the Automatic tuning method.
2 2
Press the AUTO/MAN'L button so that "AUTO"
disappears from the display.
(In this mode, stations are received in monaural.)
3 3
Press and hold the
frequency, or press and hold the
lower frequency.
Release it just before reaching the desired frequency,
and then press it repeatedly until the desired frequency
appears.
(When tuned in to a station, "TUNED" will light up on the
display.)
Note
If you tune in to an FM station manually, it is received in
monaural automatically to increase the signal quality.
Note
Pressing the TUNER input selector button on the remote
control transmitter switches the tuner from a normal tuning
mode to a preset tuning mode and vice versa.
E-20
button to tune to a higher frequency, or
button to tune to a lower frequency.
button to tune to a higher
button to tune to a