Selecting A Source Signal For The Output Line - Basler Ace User Manual

AW00123401000
Camera
Pull Up Resistor
FPGA Output
Fig. 22: Direct-coupled GPIO Line Schematic with the GPIO Line Set as an Output and with a Typical Voltage
Output Circuit (Illustration for Pin 1 as an Example; Simplified)
For more information about GPIO pin assignments and pin numbering, see Section 5.2.1 on
page 28.
For more information about setting the GPIO line operation, see a following version of the manual.
5.9.4.3

Selecting a Source Signal for the Output Line

When a GPIO line is configured to act as an output line, you must select a source signal for the line
to make the line useful. The camera has several standard output signals available and any one of
them can be selected to act as the source signal for the output line.
For more information about selecting a source signal for the output line, see a following version of
the manual.
Basler ace USB 3.0
+3.3 VDC
(Typical)
6-pin
Receptacle
1
6
3
4
2
5
Physical Interface
+3.3 to +24
VDC
Voltage
Output
Signal
to You
Your
Gnd
41