Honda Rebel 250 2016 Owner's Manual page 85

Tire Puncture Removing Wheels
u
4. Loosen the drive chain lock nuts and drive
chain adjusting nuts on both sides of the
swingarm.
5. Remove the rear axle nut while holding
the rear axle shaft at the other end with a
wrench.
6. Remove the drive chain from the rear
wheel sprocket by pushing the rear wheel
forward.
7. Remove the rear axle shaft, rear wheel
and side collars from the swingarm.
Rear axle shaft
Drive chain
adjusting nut
84
Installation
1. Install the side collars into the rear wheel.
2. Place the rear wheel between the
3. Insert the rear axle shaft from the left
4. Temporarily tighten the rear axle nut.
5. Reassemble the brake stopper arm and
Drive chain
Torque: 16 lbf·ft (22 N·m, 2.2 kgf·m)
6. Connect the brake rod to the brake arm.
7. Adjust the drive chain slack.
8. Adjust the rear brake pedal freeplay.
9. Tighten the rear axle nut.
Torque: 65 lbf·ft (88 N·m, 9.0 kgf·m)
Drive chain
lock nut
swingarm and install the drive chain over
the rear wheel sprocket.
side, through the left swingarm, wheel
hub and brake panel.
tighten the stopper arm nut.
P. 62
2
P. 68
2