Honda Rebel 250 2016 Owner's Manual page 57

Engine Oil Changing Engine Oil
u
Changing Engine Oil
Changing the oil requires special tools. We
recommend that you have your motorcycle
serviced by your dealer.
1. If the engine is cold, idle the engine for
3 to 5 minutes.
2. Turn the ignition switch off, and wait for
2 to 3 minutes.
3. Place your motorcycle on a firm, level
surface.
4. Place a drain pan under the drain bolt.
5. Remove the oil fill cap/dipstick, drain bolt
and sealing washer to drain the oil.
Discard the oil at an approved recycling
u
center.
6. Install a new sealing washer onto the
drain bolt. Tighten the drain bolt.
Torque: 18 lbf·ft (25 N·m, 2.5 kgf·m)
56
7. Fill the crankcase with the recommended
oil ( P. 43, 114) and install the oil fill cap/
2
dipstick.
Required oil
When changing oil:
1.6 US qt (1.5 liters)
8. Check the oil level.
9. Check that there are no oil leaks.
P. 54
2
Drain bolt
Sealing washer