Xerox Phaser 8560MFP/8860MFP Advanced Features Manual page 63

Setting the Duration for the Tray 2–N Prompt
The Tray 2–N prompt setting specifies the amount of time the prompt displays on the control
panel after paper is loaded in Trays 2–N. The Tray 2–N prompt requests the user to confirm
the current tray setup or to specify the correct paper type for the print job.
Setting Behavior
None Turns the tray setup prompt off.
(Default)
30 seconds Displays the tray setup prompt for 30 seconds after paper is loaded in Trays 2–N.
Infinite
Displays the tray setup prompt after paper is loaded in Trays 2
made on the control panel.
To select a duration setting for Tray 2–N prompts, use one of the following options:
■ The printer's control panel
CentreWare IS
■
Using the Control Panel
To select the Tray 2–N prompt setting on the control panel:
1. Press the System button.
2.
Select
Paper Tray Setup
3.
Select
Tray 2–N Prompt
4. Select the appropriate duration, and then press the OK button.
Using CentreWare IS
To select the Tray 2–N prompt setting using CentreWare IS:
1. Launch your web browser.
2. Enter the printer's IP address in the browser's Address field.
3. Click Properties.
4. Select General on the left navigation panel, and then select System Defaults.
5. Select the appropriate prompt setting in the Tray 2–N Prompt drop-down list.
6. Click the Save Changes button at the bottom of the page.
Phaser® 8560MFP/8860MFP Multifunction Printer
, and then press the OK button.
, and then press the OK button.
4-13
Printer Settings
–
N until a selection is