Xerox Phaser 8560MFP/8860MFP Advanced Features Manual page 57

Changing Intelligent Ready Mode
Intelligent Ready mode is an automated system that:
■ Monitors the printer's usage.
■ Warms up the printer when you are most likely to need it based on past usage patterns.
■ Activates the Power Saver mode when the printer times out.
To turn on/off the Intelligent Ready mode, use one of the following options:
The printer's control panel
■
■ CentreWare IS
Using the Control Panel
To turn Intelligent Ready mode on/off on the control panel:
1. Press the System button.
2.
Select
General Setup
3. Select
System Controls
4.
Select Intelligent Ready
5. Select Off or On, and then press the OK button to change the settings.
Using CentreWare IS
To select Intelligent Ready mode or to schedule warmup/standby settings using
CentreWare IS:
1. Launch your web browser.
2. Enter your printer's IP address in the browser's Address field.
3. Click Properties.
4.
Select the General folder on the left navigation panel, and then select Warmup.
5. Select Intelligent Ready, Scheduled, or Job Activated from the Warmup Mode
drop-down list to change the setting.
6. If you selected Scheduled in Step 5, make selections for each day's warmup setting and
standby setting.
7. Click the Save Changes button at the bottom of the screen.
Note: Although the control panel selections only enable you to turn Intelligent Ready mode
on or off, CentreWare IS enables you to specify particular printer Warmup modes and settings.
Phaser® 8560MFP/8860MFP Multifunction Printer
, and then press the OK button.
, and then press the OK button.
, and then press the OK button.
4-7
Printer Settings