Xerox Phaser 8560MFP/8860MFP Advanced Features Manual page 62

Selecting Tray 2-N Mode
The Tray 2-N Mode setting specifies:
■ How Tray 2-N paper type and size are determined when you load paper in the tray but do
not select the paper type and size on the control panel.
Setting
Dynamic
(Factory default setting)
Static
To select the Tray 2-N mode setting, use one of the following options:
■ The printer's control panel
■ CentreWare IS
Using the Control Panel
To select a Tray 2-N mode setting on the control panel:
1. Press the System button.
2. Select
Paper Tray Setup
3. Select
Tray 2-N Mode
4. Select the appropriate setting, and then press the OK button.
Using CentreWare IS
To select a Tray 2-N mode setting using CentreWare IS:
1. Launch your web browser.
2. Enter the printer's IP address in the browser's Address field.
3. Click Properties.
4. Select the General folder on the left navigation panel, and then select System Defaults.
5. Select the appropriate setting in the Tray 2-N Mode drop-down list.
6. Click the Save Changes button at the bottom of the page.
Phaser® 8560MFP/8860MFP Multifunction Printer
Description
Uses the settings from the next print job that prints from Tray 2-N to
■
determine the paper size and type.
The paper size and type already set for Tray 2-N stay in effect.
■
, and then press the OK button.
, and then press the OK button.
4-12
Printer Settings