LG Pro:Centric 43UT570H Setup Manual page 25

SEARCHING FOR PRO:CENTRIC SERVER
This step automatically searches for the Pro:Centric Server.
If there is no Pro:Centric Server installed, you do not need to continue with this procedure.
In this case, you can either select
PRO:CENTRIC below to enter the Pro:Centric Server settings manually.
Status: Tuning channel 30
TV is now searching the pre-defined channels for the data channel...
MANUAL PRO:CENTRIC
BACK
Automated Pro:Centric Configuration
Note: If the server is not yet configured on the system or if Pro:Centric data delivery will be over
IP and there is no Domain Name System (DNS) server, use the manual configuration option to
configure the TV's Pro:Centric server settings (see "Manual Pro:Centric Configuration" subsection
on page 26). See also note below regarding DNS requirements.
Note: If there is a DNS server at the site, you can create a "procentric.local" DNS entry with the
Pro:Centric server's IP address. Also, the Pro:Centric server's port number must be set to "80" to
allow the automated Pro:Centric IP configuration via the EZ-Manager to find the server.
Once the Pro:Centric data channel is found (a Pro:Centric Server Was Found screen will be
displayed) and the Pro:Centric Application Mode is determined, the wizard will advance to the
Processing the Pro:Centric Configuration screen, which shows the progress of the data
downloads (see example on following page). Note that some steps may require a few minutes.
If the process is successful, no further user interaction is required, though, in some instances,
where the option (for example, "NEXT") is available, you may manually move forward to subsequent
steps within the wizard to speed up the process.
PROCESSING THE PRO:CENTRIC CONFIGUR...
Downloading the Pro:Centric application files takes a few minutes.
Please wait...
2%
Retrieving files from data channel 70
Application files In progress...
Maintenance files Synchronizing...
Warning - Do not remove AC power or the signal cables during these steps.
206-4341
in the top right corner of the screen to exit or select MANUAL
X
EZ-Manager Wizard (Cont.)
X
04
(Continued on next page)
25