Checking And Replacing The Dry Ink Waste Container - Xerox DocuPrint 4890 IPS Maintenance Manual

Checking and replacing the dry ink waste container

XEROX DOCUPRINT 4850/4890 IPS GUIDE TO PERFORMING ROUTINE MAINTENANCE
4. Use the cap from the new container to recap the old container.
5. Discard the waste material and container according to the
instructions on the label.
6. Grasp the new, empty container with both hands, one hand on
the handle and one on the container tab. Lift the front of the
container over the notch at the front of the compartment, so that
the notch slides into the groove running underneath the
container.
7. Make sure that the container is pushed all the way into the
compartment.
8. Close the printer doors.
9. Dispose of the drop cloth.
Waste dry ink is transported into the sealed waste container located
in a compartment in the lower left corner at the rear of the printer. The
waste material is a mixture of black and color developer waste, and
is not reusable.
When the dry ink waste container is approximately three quarters full,
the Attention light turns a steady yellow. Replace the container as
soon as possible. Once the container is full the printer stops and does
not resume printing until the container is replaced. The Attention light
turns a modulated yellow and the message DRY INK WASTE
CONTAINER FULL displays on the printer control console.
WASTE CONTAINERS
6-3