Siemens SIMATIC HMI KTP400 Manual page 21

4 Installation and Commissioning
No. Action/response
In the project tree under "KTP400
3.
[KTP400 Basic PN]" go to
"Connections" and select it with a
double click.
In "HMI device", enter the IP address of
4.
your Basic Panel (here: 192.168.1.80)
and press Enter to confirm.
Make sure that

"S7ONLINE" is specified under
"Access point".

the master LOGO! IP address
is specified under "PLC" (here:
192.168.1.13).

the check box "Cyclic
operation" is ticked.
In the project tree, go to "Devices &
5.
networks" and select it with a double
click.
Make sure a subnet has been added to
6.
the network. To create a subnet in the
network, open the context menu with a
right click on the Ethernet interface and
click on "Add subnet".
Note:
In this application example, the subnet
has already been added in the WinCC
project.
House Control and Weather Sensors - LOGO! Set 11
Entry ID: 68585346, V2.1, 09/2018
WinCC
21