Error Messages - Xerox 8825/8830 Operator's Manual

PROBLEM SOLVING
Media Jams
A
8. Unlatch (A) and open (B) the Cutter Drawer.
9. Locate and remove any media from the Cutter area.
10. Close the Cutter Drawer.
11. The printer will resume printing when all jam locations have been cleared.
If the problem continues, call for service.
B
XES Synergix 8825/8830 Printer Operator Manual

Error Messages

ERROR MESSAGE
CHECK FOLDER Finisher Config Type
enabled but no folder is
FOLDER
installed.
COMMUNICATIONS
ERROR #17
F2-01 CHECK Finisher Config Type
FOLDER enabled but no folder is
installed.
FOLDER
COMMUNICATIONS
ERROR #01
PROBLEM SOLUTION
1. Press the
ONLINE/OFFLINE
button to take the
printer OFFLINE.
2. Refer to Finisher
Settings on page
27 and reset the
value to NONE
1. Switch OFF the
Printer.
2. Wait 5 seconds and
switch ON the
printer
3. As soon as the
Printer Firmware
Version message is
displayed, press the
ONLINE/OFFLINE
button to take the
printer OFFLINE.
4. Refer to Finisher
Settings on page
27 and reset the
value to NONE
30