Xerox 8825/8830 Operator's Manual page 44

Product Specifications
XES Synergix 8825/8830 Printer
Electrical Specifications
105 - 125 VAC (Nominal 60 Hz)
210 - 225 VAC (Nominal 50 Hz)
20 Amp dedicated circuit
Power Consumption
120 Watts: (Power Saver Mode)
1000 Watts (heaters on - standby)
690 Watts (Ready Mode)
1840 Watts (running)
Heat Dissipation
6,270 BTU (running)
Warm-up Time: 2 minutes
Environmental Requirements
Temperature: 60° F (10° C) to 80° F
(27° C)
Humidity: 20% to 80% Relative
Humidity
Maximum Elevation: 7000 feet (2133 m)
above sea level
Media Specifications:
Media Type:
Bond (20 lb.)
Vellum (20 lb.)
Film (4 mil.)
Tracing (4 mil)
Media Size:
Roll Feed - 11 inches to 36 inches (279.4 mm to
914.4 mm) width (3 (76.2 mm) inches core
diameter to 6.7 inches (170.2 mm) O.D.) (Roll 2
is optional for the 8825, Roll 3 is not available
for the 8825).
Manual Bypass Feed (optional for the 8825) -
11 inch to 36 inch (279.4 mm to 914.4 mm)
Print Size:
Minimum Cut Sheet - 8.5 X 11 inches (216 mm
x 279 mm)
Minimum Roll Feed - 11 X 8.5 inches (279 mm
x 216 mm)
Maximum Length - 48ft, (15.2 m) (Standard with
the 8825/8830 Controller) 80 ft (24.4 m)
(Optional)
XES Synergix 8825/8830 Printer Operator Manual
Audible Noise
67 dBA) Maximum
.
40