Battery Installation/Replacement - Detecto ICON Series Owner's Manual

Battery Installation/Replacement

To install or remove the batteries, the following steps should be followed:
1. Make sure the AC power adapter is unplugged.
2. Remove the platform cover from the scale base.
3. Referring to Figure No. 1, locate the two (2) rectangular panels in the scale base.
4. To install or replace the batteries, first remove each battery holder cover by pushing in
on the tab and lifting it up exposing the battery holders. See Figures No. 2 and 3.
5. If installing new batteries, proceed to step 6. If replacing the batteries, remove all 6
batteries from the battery holder and then proceed to step 6.
6. Referring to Figure No. 4, install six (6) "AA" size batteries in each holder, noting the
polarity markings located in the battery holder.
7. After placing six (6) batteries in each holder, replace the battery covers.
Figure No. 1
8. Install the platform cover on the scale base and press the
9. If display turns on, batteries have been installed correctly. If not, remove the platform
cover and then the battery covers and check for one or more improperly positioned
batteries.
10. The scale is now ready for operation.
3300-0192-0M Rev H icon Clinical Scale Owner's
Figure No. 2 Figure No. 3 Figure No. 4
key.
7