Table of Contents
Advertisement
SETUP AND INSTALLATION, CONT.
USB Port
The USB port on the VET550 Digital Veterinary Scale may be connected to a computer for
transmission of weight data to an EMR (electronic medical record) software program. The
weight data will be transmitted automatically (if selected in Configuration) once the weight is
stable or also selected in Configuration when a weight request from the host computer is
received. For a breakdown of the data format transmitted, refer to the PRINT OUTPUT
SETTING DATA FORMAT section of this manual.
TARE SWITCH
The tare switch is not used on the VET550 Digital Veterinary Scale.
Batteries
The VET550 Digital Veterinary Scale can use (4) AA 1.5V alkaline batteries (not included). If
you wish to operate the scale from batteries, you must first obtain and install the batteries
before operations can begin. Batteries are contained in a battery holder inside the display.
Access is via a removable door on the back of the display.
Battery Installation/Replacement
The VET550 Digital Veterinary Scale operates from four (4) AA batteries. Note that Alkaline
are recommended. To install or replace the batteries, the following steps should be followed:
1. Remove the weight display from the
weight display mounting bracket.
2. Unplug the display cable from the bottom
of the weight display.
3. Place the display face down on a flat
surface.
4. Remove the battery compartment door.
5. When installing new batteries, proceed to
step 6. When replacing the batteries,
remove all four batteries from the battery
holder and then proceed to step 6.
6. Install the four new batteries in the battery holder noting the polarity markings located in the
battery holder.
7. Replace the battery compartment door.
8. Turn the weight display over (display facing up), and then press the ON/OFF key.
9. If the display turns on, the batteries have been installed correctly. If not, remove the battery
compartment door and check for one or more improperly positioned batteries.
10. Plug the display cable into the bottom of the weight display and then set the weight display
on the bracket.
11. The scale is now ready for operation.
1961-0397-0M VET550 Owner's Manual
5
Advertisement
Table of Contents
