Table of Contents
Advertisement
BATTERY OPERATION, CONT.
Battery Installation/Replacement
To install or remove the batteries, the following steps should be followed:
1. Make sure the AC power adapter is
unplugged.
2. Remove the indicator from the scale
column bracket. (Referring to Figure
No. 4, pull the spring plunger down and
slide the indicator up and away from the
bracket).
3. Turn the indicator over so that the display
is facing away from you.
4. Locate the rectangular panel on the back
of the indicator.
5. To install or replace the batteries, first
remove the battery holder cover by
pushing in on the tab and lifting it up.
Refer to Figure No. 5.
6. If installing new batteries, proceed to step
7. If replacing the batteries, remove all 6
batteries from the battery holder and then
proceed to step 7.
7. Install the 6 new "AA" size batteries in the
battery holder, noting the polarity
markings located in the battery holder.
Refer to Figure No. 6.
8. After placing all 6 batteries in the holder,
replace the battery cover.
9. Turn the indicator over (display facing up)
and press the ON/OFF key.
10. If the display turns on, the batteries have
been installed correctly. If not, remove the
panel and check for one or more
improperly positioned batteries.
11. Return the indicator to the scale column
bracket. Refer to the steps on page 3.
12. The scale is now ready for operation.
For more information on setup and
operation of the indicator, see the
750 Owner's Manual (8555-M483-O1).
8525-0386-0M Rev A Digital Chair Scale Owner's Manual
Figure No. 4
Battery
Cover
Figure No. 5
+
-
+
-
+
-
Figure No. 6
Spring
Plunger
Release
Push in and
lift here
-
+
-
+
-
+
5
Advertisement
Table of Contents
