Raven SmarTrax Installation Manual page 30

Install the sensor onto the Steering position sensor bracket as shown in the following diagram.
The '1' mark should be set so that it is in-line with the silicon filled sensor hole.
Once the sensor is set, tighten all of the linkages and set screws.
Start the tractor and slowly turn the wheel from right to left with someone watching to make
sure that the sensor assembly is not too short, or does not over-center.
The length of the threaded rod will need to be adjusted if this should happen.
Connect the SPS cable to the Smartrax wiring loom.
Place the DO NOT STEP warning sticker onto the SPS Sensor arm. (Be sure that the surface
is clean.)
28