Ethernet model
• Recommended cable gauge: 0.3 to 0.75 mm
Safety communication model
• Recommended cable gauge: 0.3 to 0.75 mm
Wiring method
Power supply connection
Use crimp terminals and stripped wire for the control circuit wiring. For single wire, the stripped wire can be used without crimp
terminal.
Connect the end of wires (crimp terminal or stranded wire) to the terminal block.
1.
Strip the signal wires as shown below. If too much of the wire is stripped, a short circuit may occur with neighboring
wires. If not enough of the wire is stripped, wires may become loose and fall out.
Twist the stripped end of wires to prevent them from fraying. Do not solder it.
2
2
Cable sheath stripping length
S1 S2 PC D10 DI1 SD
SO SOC
10
2
5
4
B
A
C
SX1 SX2 PC SD
SY1
SC1
SY2
SC2
10
2
5
4
A
B
C
2. Installation and Wiring
2.6 Control circuit
1
2
3
4
5
6
7
8
9
10
53