Related Manuals for Atlas Copco PBE 6 S
Summary of Contents for Atlas Copco PBE 6 S
- Page 2 Repair Instructions No.182.03/98 PAGE PBE 6 S Special Tools Torx screwdriver TX 30 4932 319 998 Required Forcing disks 4931 599 018 Pulling-off device 9170 314 440 Adjustment tool for carbon brushes 9170 302 270 Important! Before beginning the maintenance work, perform an initial check with a high voltage test according to VDE (see chapter Electrical and Mechanical Test Instructions).
- Page 3 Repair Instructions No.182.03/98 PAGE PBE 6 S Detaching the Loosen the screws (1) and remove the carbon brushes brush covers (2). Lift the brush springs (5) off the respective carbon brushes (3) and place them on the upper edge of the brush holders (4).
- Page 4 Repair Instructions No.182.03/98 PAGE PBE 6 S Detaching the Loosen the two short (A) and the two armature long (D) screws. Remove the motor housing (9) with the field (1) and the air deflector ring (2). Remove the air deflector ring (2) from the motor housing (9) and expel the field (1) from the motor housing (9).
- Page 5 Repair Instructions No.182.03/98 PAGE PBE 6 S Detaching the Remove the sleeve (2), and the O-rings flange (3) and 4). Loosen the screws (1) and remove the flange (5) with the ring (8). Remove the spindle sleeve (7) from the housing (6).
- Page 6 Repair Instructions No.182.03/98 PAGE PBE 6 S Detaching the Loosen the two screws (A) and remove crankshaft the service cover (8) with the gasket (B) and the valve (9). Remove damaged welch plug (7). Remove the spring ring (1). Pull off the crank wheel (2) with aid of a pulling-off device (service tool).
-
Page 7: Maintenance
Repair Instructions No.182.03/98 PAGE PBE 6 S Maintenance General It is recommended to submit the machine to maintenance after the carbon brushes have switched off. Cleaning Clean all parts – with the exception of the electrical parts – with cold cleaning agent. Caution! No clean- ing agent should penetrate into the bearing. - Page 8 Repair Instructions No.182.03/98 PAGE PBE 6 S Assembly Mounting the Press the needle bearing (2) into the con- cylinder and the necting rod (1). connecting rod Push the percussion body (A) and the gasket (9) into the cylinder (8). Put together the cylinder (8) and the con- necting rod (1) and push the cylindrical bolt (7) through both borings.
- Page 9 Repair Instructions No.182.03/98 PAGE PBE 6 S Mounting the Press the needle bearings (4 and 7) into gear box cover the gear box cover (3). Place the insert (5) into the gear box cover (3) (mind the right position!) and fit the gasket (6).
- Page 10 Repair Instructions No.182.03/98 PAGE PBE 6 S Mounting the Push the insulating disk (5) and the armature ring (7) over the armature shaft and press on the armature bearings (4) and (8). Push the bearing sleeve (3) over the ar- mature bearing (4).
- Page 11 Repair Instructions No.182.03/98 PAGE PBE 6 S Mounting the Mount the carbon brushes (3) and mount carbon brushes the cable lugs (h) and (i) on the field. Insert the carbon brushes (3) into the brush holders (4). Pull up the brush springs (5) of the brush holders (4) and push them over the carbon brushes (3).
Need help?
Do you have a question about the PBE 6 S and is the answer not in the manual?
Questions and answers