g) Rotate the Rear Web Edge Sensor Adjustment Knob until the end of the shaft is
flush with the mounting block at the rear of the cavity.
h) Grasp the Rear Web Edge Sensor Knob and gently push it into the Printer until it
stops.
i) Close the Brass Clamp.
1
Thumbscrew
Front Web Edge Sensor Adjustment Knob
2
Rear Web Edge Sensor Adjustment Knob
3
4
Brass Clamp
®
Xerox
CiPress 325 / 500 Production Inkjet System
Web Threading Guide
Preparing the Infeed Module for Threading
2-7