Web Registration Procedures - Xerox CiPress 325 Web Threading Manual

Web Registration
Procedures
Once web threading is complete, you will need to register the web at the Primary CiPress
and, if this is a tandem system, the Secondary CiPress . Use the following procedure to
register the web prior to
1. Open the Infeed Module Front Door and access the lower front left cavity of the
Infeed Module.
2. With a tape, measure the actual width of the web to the nearest millimeter. Record
the value. Use this value for the
3. Use the following formulas to determine the target web edge position from the inside
of the Infeed Module Front Frame Plate.
Note
The actual web edge position should be within +/- 3 mm of the target web edge
position calculated.
a) If the web is at the Left Rear Metal tab on the Primary CiPress , use the following
formula:
(577 mm) - (web width) = result
mm) width web is:
b) If the web is at the Right Rear Metal tab on the Primary CiPress , use the following
formula:
(610 mm) - (web width) = Result
width web is:
(610 mm) - (508 mm) = 102 mm
®
Xerox CiPress 325 / 500 Production Inkjet System
Web Threading Guide
Setting Up and Activating the Web Registration
variable in
web width
. An example of the formula for 18 inch (120
(577 mm) - (457 mm) = 120 mm
. An example of the formula using 20 inch
the next step.
.
.
8
Module.
8-1