Speed Transducer For Tractor; Road Safety Kit; Power Supply - Hardi NK SB Series Instruction Book

4 - Sprayer Setup

Speed Transducer for Tractor

Note the following if the speed transducer is fitted to the tractor.
The speed transducer (A) and the speed ring should be located at the
inside of the tractor's right wheel. The sensor is an inductive type that
requires a metallic protrusion (e.g. a bolt head) passing by in order to
trigger a signal. It should be adjusted, so that the transducer is placed to
the centre of the holes in the speed ring (vertical direction).
Recommended distance between protrusion and transducer (A) is 3 to
6 mm. Check this in the entire circumference.
Correct fitting is indicated by a constant flashing of the transducer, when
the wheel is rotating.

Road Safety Kit

Connect the plug for rear lights to the tractor's 7-pin socket and check the function of rear lights, stop lights, side lights and
direction indicators on both sides before driving.
The wiring is in accordance with ISO 1724. See the section "Technical Specifications".
μ
ATTENTION! Turn OFF all work lights when driving on public roads!

Power Supply

Power requirement is 12 V DC. Always note polarity! For proper function
of the electric equipment, the wires must have the following
recommended cross sectional areas and correct fuses to ensure a
sufficient power supply.
The delivered power connectors follows the standard of most modern
tractors. If you have a tractor with another power connector, it is
necessary to disassemble the connector and fit it to the actual tractor
connector.
The number and the type of connectors may vary on the specific
sprayer, depending on its equipment.
Cigar connector, 1-pin
Spray control unit requires:
Wire 2.5 mm
Hydraulic control unit requires:
Wire 4.0 mm
EVC Spray Box connector, 39-pin
The unit requires:
Wire 39 x 1.0 mm
The cable is custom made and must not be
changed to another type.
60
2
. Fuse 10 amps.
2
. Fuse 16 amps.
2
Traffic light connector, 7-pin
The unit requires:
2
Wire 6 x 1.5 mm + 1 x 2.5 mm
The cable is custom made and must not be
changed to another type.
2