Sprayer Setup; General Info; Unloading The Sprayer From The Truck; Before Putting The Sprayer Into Operation - Hardi NK SB Series Instruction Book

General Info

Unloading the Sprayer from the Truck

For the unloading of the sprayer, you need a crane. When unloading
with a crane, please observe the lifting points as shown in the picture,
and make sure that the straps or belts used for lifting are strong enough.
€
DANGER! Lifting of machines require special training according
to national regulations.
μ
ATTENTION! Only lift the sprayer when the tanks are empty!

Before Putting the Sprayer into Operation

Although the sprayer has been supplied with a strong and protective surface treatment on steel parts, bolts etc. in the
factory, it is recommended to apply a film of anti-corrosion oil (e.g. CASTROL RUSTILO or SHELL ENSIS FLUID) on all metal
parts in order to avoid chemicals and fertilizers discolouring the enamel.
If this is done before the sprayer is put into operation for the first time, it will always be easy to clean the sprayer and keep
the enamel clean for many years. This treatment should be carried out every time the protection film is washed off.

4 - Sprayer Setup

53