Table of Contents
Advertisement
Avab Jaguar
1
Shutdown Pronto: Alt-X on the keyboard or File menu – Shutdown
Monitor displays: C:>\PRONTO
2
Edit PRONTO.CFG using MSDOS command EDIT: EDIT PRONTO:CFG
See example from figure 27
3
Update dongle code: Insert new line in line marked SystemConfig
Please note blanks between groups of characters!
4
Change number of channels: Change number in line marked Channels
Hardware dongle limits number to the number ordered
5
Change number of outputs: Change number in line marked Outputs
Hardware dongle limits number to the number ordered
6
End EDIT, save file
7
Save data: Insert formatted floppy disk into drive
Copy file PRONTO.CFG to floppy disk
Command: COPY PRONTO.CFG A:
6
Restart Pronto by typing command p
Pronto should handle now the new number of channels and outputs.
Pronto Startup File
On power on Pronto comes up with MSDOS. Last step in this procedure is an automatic call to the startup file
P.BAT from AUTOEXEC.BAT. This batch file consists of one line starting PRONTO.EXE with some options as
needed. Refer to the manual about those options.
P.BAT can be edited using MSDOS command EDIT.
Example P.BAT
PRONTO /HARDDISK /TTVIDEO 1
Those two options signal Pronto to use the built in harddisk (not the former used flashdisk) and two monitors.
Never change or replace a DOS file if you are not sure on your action. Such an operation should be
executed by trained personal of your dealer or transtechnik only. If it is done by unqualified personal
you loose warranty.
Pronto_Peak603VL_eng
Version 1.2, Nov. 2003
Edit PRONTO.CFG
Change Configuration
– 34 –
- Quick Links:
- Table of Contents
Hide quick links:
Advertisement
Table of Contents
