Change Fan - ETC Avab Jaguar Service Manual

Avab Jaguar
Take care on electric charges
For handling of CPU board please refer to instructions on page 6
To avoid mix up on installation care for clear labeling of cables connected to the CPU
1
Unplug all cables, if necessary, unfasten screws
2
Unfasten 6 screws to base panel
Unlock and remove RAM-module, will be used again
1
Insert CPU-card and attach it by 6 screws
2 Insert RAM module, verify locking
3 Plug in all cables
Notice red marking of flat cables.

Change Fan

Figure 8: detailed view of CPU fan
1 Remove fastening screws
2 Disconnect fan power from CPU
3 Insert new fan and fasten it with four screws
Do not press onto the fan. Fan bearing might be damaged.
4 Connect fan power to CPU
Pronto_Peak603VL_eng
Version 1.2, Nov. 2003
Remove
Install
Procedure
Bottom Part
– 13 –