Table of Contents
Advertisement
Overall system design
To specifically reduce bearing currents, you must consider the system as a whole, which
comprises the motor, converter, and driven machine. The following measures support you
when reducing bearing currents and help to avoid damage:
● In the overall system, set up a properly meshed grounding system with low impedance.
● Use the common-mode filter (damping cores) at the converter output. The Siemens sales
representative is responsible for selection and dimensioning.
● Limit the rise in voltage by using output filters. Output filters dampen the harmonic content
in the output voltage.
● The operating instructions for the converter are not part of this documentation. Refer to
the configuration information for the converter.
4.14.4
Insulated bearings when operated with a converter
If the machine is operated from a low-voltage converter, insulated bearings are fitted at the
NDE and an insulated encoder with insulated bearings (option).
Comply with the plates on the machine relating to bearing insulation and possible bridges.
①
②
③
Figure 4-2
NOTICE
Bearing damage
The bearing insulation must not be bridged. Bearing currents can damage bearings.
• Also for subsequent installation work, such as the installation of an automatic lubrication
• Please contact the service center if necessary.
1MB155 / 1MB555
Operating Instructions, 03/2018, A5E41926185A
Driving machine
Motor
Coupling
Schematic representation of a single drive
system or a non-insulated vibration sensor, make sure that the bearing insulation cannot
be bridged.
4.14 Converter operation
④
Insulated bearings
⑤
Insulated tachometer fitting
Preparations for use
47
Advertisement
Table of Contents
